Windows registry stores the most essential information concerning your computer. The registry holds information of hardware and software installed and other related data. How Windows is configured during setup and every time new hardware and software are added also saves in the registry. In fact, big or small changes you made on computer will reflect on that part of the system data – the Windows registry. More
Windows registry contains complex system information about how the programs will run. Windows in general will make changes to registry every time a new hardware and software is installed, removed or changed. Usually, editing a registry is vital in removing threats from the computer. Some anti-virus programs may remove files but not the value or entries it threat have registered. More
Starting Windows in Safe Mode is very useful when troubleshooting computer problems by limiting the resources it loads when Windows is started. While in Safe Mode, users will start with only basic options and will load only basic drivers. Starting this way can help users diagnose systems problems easil The computer must be in Off mode to enter the Safe Mode menu. More
Information provided on this page is How to disable System Restore on Windows ME and prevent the viruses on infected data from being restored. System Restore is part of Windows ME, which was by default is turned on during the installation process. Turning Off system restore may remove previous restore points so it is advised to do this if there are no used of your previous restore points.
1. On the Desktop, Right Click on My Computer
2. Select the System Properties
3. On Performance Tab, Click File System in Advanced Settings at the bottom.
4. On Troubleshooting Tab, Mark Disable System Restore t disable or Unmark to enable.
4. Click OK
5. When asked to Restart Windows, click Yes.
Note: If you turn off System Restore for troubleshooting purposes such as Virus removal, don’t forget to turn it on again again after the removal process. You must create new restore points once you turn System Restore back on.
Information provided on this page is How to disable System Restore on Windows XP and prevent the viruses on infected data from being restored. System Restore is part of Windows XP, which was by default is turned on during the installation process. Turning Off system restore may remove previous restore points so it is advised to do this if there are no used of your previous restore points.
You must have an Administrator Privilege to be able to disable System Restore on Windows XP.
1. On the Desktop, Right Click on My Computer
2. Select the System Restore Tab
3. Mark the “Turn Off System Restore” to disable and UnMark to Enable
4. Click Apply on the Bottom of the Dialog Box to save the settings.
5. A message “This deletes all existing restore points” will appear, click Yes to disable.
6. Click OK.
Note: If you turn off System Restore for troubleshooting purposes such as Virus removal, don’t forget to turn it on again again after the removal process. You must create new restore points once you turn System Restore back on.